پسورد ریکاوری سوئیچ سیسکو cisco

پسورد ریکاوری سوئیچ سیسکو cisco
پسورد رکاوری سویچ dist4500x
Password Recovery Procedure for the Catalyst 4500 switch (deleting configuration)
Jump to navigationJump to search
Cisco WS-C4500X-32SFP+ /A set to default, JK

***** The system will autoboot in 5 seconds *****
Type control-C to prevent autobooting.
. . .
Autoboot cancelled……… please wait!!!
rommon 1 > [interrupt]

rommon 1 >confreg

Configuration Summary :
=> console baud: 9600
=> autoboot from: commands specified in ‘BOOT’ environment variable
do you wish to change the configuration? y/n [n]: yes
enable “diagnostic mode”? y/n [n]:
enable “use net in IP bcast address”? y/n [n]:
enable “load rom after netboot fails”? y/n [n]:
enable “use all zero broadcast”? y/n [n]:
enable “break/abort has effect”? y/n [n]:
enable “ignore system config info”? y/n [n]: y
change console baud rate? y/n [n]:
change the boot characteristics? y/n [n]:
Configuration Summary :
=> ignore system config info
=> console baud: 9600
=> autoboot from: commands specified in ‘BOOT’ environment variable
do you wish to save this configuration? y/n [n]: yes
You must reset or power cycle for new configuration to take effect

rommon 2 >boot

The system will autoboot in 5 seconds *****

Type control-C to prevent autobooting.
. . .
Autoboot cancelled……… please wait!!!
rommon 1 > [interrupt]

rommon 2 >clear config all

This command will clear all configuration in NVRAM.
This command will cause ifIndex to be reassigned on the next system startup.
Do you want to continue (y/n) [n]? yes
Clearing NVRAM… done!
rommon 3 >boot
https://wiki.nesevo.com/index.php/Password_Recovery_Procedure_for_the_Catalyst_4500_switch_(deleting_configuration)